My Patreon patrons will find there are now two new blog posts from me with a printable-size ‘Ulthar Post’ stamp. I realised that one can treat Patreon like a private patrons-only blog, so now that I know how to do it there will be more such posts.

It might look good on Christmas parcels, as well as hand-delivered Christmas cards.

The edge-deckling is in the cutout .PNG, but you might find it’s a bit tricky to add that by hand. Especially if you print it on paper at less than about four inches. Serrated shears of the sort used for fabrics are going to be too large, but careful use of a sharp X-Acto (USA) or Stanley (UK) knife to form deckling might do it. As it’s a PNG with a transparent edge it might also be used as a template for a very thin bit of 3D-printing — you might get an amusing beer-mat or fridge-magnet out of it.

Putting a simple drop-shadow on it before you print, and then printing on paper the same white colour as the envelope should also reveal the deckling.

You could of course get some real but large stamps of low value, and carefully stick the Lovecraft square over the top.